NOTICE OF SOFTWARE RELEASE: iQUBE3 CPU Board V1.01.00
07/22/26

•    Fieldbus – The weight value returned to the PLC no longer contains a decimal point when not configured to do so
•    Fieldbus – Ethernet/IP subnet and gateway are now written to their correct input registers
•    General – The iQUBE3 no longer intermittently locks up when transitioning from setup to weigh mode using the KSAVEEXIT command
•    Fieldbus – Commands are now being sent correctly to the PLC due to Modbus request handling not working properly
•    Fieldbus – Corrected an issue with the yellow LED not showing that it was communicating on the SCT module
•    EDP Command – SC.NCELLS modifications are now no longer allowed in weigh mode


NOTICE OF SOFTWARE RELEASE: iQUBE3 CPU Board V1.00.01
03/23/26

•    Scale calibration audit count now correctly updates in certain instances 
•    Emulation snapshots are now corrected to capture first stable weight over threshold 
•    Corrected power supply voltage diagnostic limits 
•    Now can emulate a load cell if it is disconnected 
•    Fixed an inconsistent section match calibration error 
•    Load cell overload and underload error no longer being recorded multiple times 
•    SC.WEIGHT command now works for total scale 
•    SDCARD.STORE command no longer causes communication issues when a dual serial card is in the system 
•    Cell Error LED’s – If you have multiple cell errors, the LED’s no longer continue to show errors until every cell is out of error 


NOTICE OF SOFTWARE RELEASE: iQUBE3 CPU Board V1.00.00
01/28/26

•    Initial firmware release
